Expert Answers about Coachmen Freelander Motorhome

• What Amperage Circuit Breaker is Required for the Hott Rod RV Water Heater Conversion Kit # DGR6VP?
• I confirmed with Diamond Group that the Hott Rod RV Water Heater Conversion Kit - Propane to Electric # DGR6VP needs a 15-amp circuit breaker. As far as the wiring for the Replacement Single-Panel On/Off Switch for Atwood Gas and Electric Water Heaters # AT91959, I went ahead and attached the wiring diagram to this answer. You will use the setup that lists your water heater model in the list in the upper left corner of each of the three diagrams.
  view full answer...


• Brake Controller Plug Location on a 2014 Coachmen Freelander with Factory 7-Way Trailer Connector
• The connector that you found under your dash is actually the OBD-II port which is why it doesn't quite match up with a brake controller adapter, like part # 3034-P which fits Tekonsha and Draw-Tite brake controllers. Typically we find on motorhomes that the brake controller plug is up under the driver's side dash, next to the steering column, or under the driver's seat. From what I could find it looks like your 2014 Coachmen Freelander was built on a 2013 Ford E-350 chassis. If you skip...
  view full answer...


• How To Install Prodigy P2 Brake Controller On 2016 Coachman Freelander Motorhome
• Underneath the dash over in the lower left corner where the emergency brake is located, is a black fuse box. Remove the lid exposing the ports in the fuse box and plug in your Tekonsha Wiring Adapter # 3034-P for your Prodigy P2 Brake Controller # 90885. I have included pictures in this answer page for reference as well as a video.
  view full answer...


• Brake Controller Connection Port on Coachmen Class C Motorhome Based on 2010 Ford E-450 Chassis
• If your Ford E-450-based Class C motorhome has a factory 7-way connector with a blue brake circuit wire then there should indeed be a brake controller connection port to allow plug-and-play installation of a controller like the Prodigy P3 # 90195 that will use the part you referenced, harness # 3034-P. If you refer to the linked photo you'll see the spot on the dash behind which the connector is typically found. The mating gray connector you'll look for will be similar in size and shape...
  view full answer...


• How To Install Redarc Tow-Pro Elite Trailer Brake Controller On 2020 Coachmen Freelander Motorhome
• The Redarc Tow-Pro Elite Trailer Brake Controller part # RED44FR comes with everything needed for installation on models with factory trailer brake pre-wiring under the dash. I do not believe there is any such wiring on a 2020 Coachmen Freelander Motorhome therefore you'll need some extra wires and circuit breakers. The Wiring Kit for 2, 4, 6, and 8 Brake Electric Trailer Brake Controllers part # 5506 has this but you many need to extend the wires since it's a longer vehicle.
  view full answer...


• Brake Controller Adapter Location on a 2016 Coachmen Freelander 22QB Motorhome
• You are correct that the Plug-In Wiring Adapter # 3034-P is what you need to install the Tekonsha Prodigy P2 # 90885 on your 2016 Coachmen Freelander Motorhome with the Ford E-350 chassis. The location of the brake controller adapter is in the same location for your motorhome that it is on a Ford van or pickup truck behind the dashboard. You can locate it by finding the notch in the access panel near the middle of your dash on the passenger side. Carefully pry that panel out and undo the...
  view full answer...